Nikon Projector VT650 User Manual

Step 3  
Turn on the projector.  
Remote Control Features  
11 Enter (Left click) Button  
1
SOURCE  
2
When you are in the Computer mode, this button works as the  
mouse left button.  
OFF  
ON  
POWER  
4
Quick Connect Guide  
3
VIDEO S-VIDEO RGB  
AUTO ADJ.  
M
E
N
U
5
6
AUTO  
8
When you are in the Projector mode, which is indicated by light-  
ing the PJ button:  
ADJUST  
SELECT  
E
N
STATUS  
E
7
POWER  
R
9
Use this button to enter your menu selection. It works the same  
way as the “Enter” button on the cabinet.  
C
A
N
C
E
L
Connections  
10  
11  
SELECT  
ON  
/
STAND BY  
12  
12 Cancel (Right click) Button  
PJ  
NOTE: To turn off the projector,  
press and hold the POWER button  
for a minimum of two seconds.  
When you are in the Computer mode, this button works as the  
mouse right button.  
Step 1  
Connect the supplied 15pin-15pin signal cable.  
13  
15  
PICTURE  
HELP  
ASPECT  
14  
16  
19  
When you are in the Projector mode, which is indicated by light-  
ing the PJ button:  
FREEZE PIC-MUTE  
Power button  
18  
17  
For older Macintosh computers, use a  
commercially available pin adapter to  
connect to your Macintosh’s video port.  
MAGNIFY  
Press this button to exit “Menus”. It works the same way as the  
“Cancel “ button on the cabinet.  
VOLUME  
20  
Connecting the remote  
mouse receiver to your  
computer.  
Step 4  
Set up the Projector.  
13 PJ Button  
To adjust the projector’s focus or to zoom in and out use  
the Focus ring or Zoom lever on the lens.  
Press this button to switch the Select, Cancel, and Enter buttons  
between the Projector mode (lit red)and the Computer mode. Press  
this button or any one of the Power ON/OFF, Menu, Help and Mag-  
nify buttons to switch to the Projector mode and the PJ button lights  
red. To switch back to the Computer mode, press the PJ button again.  
NOTE: If you are using a Macintosh computer, you can click either  
the right-click or left-click button to activate the mouse.  
To optimize image, press the AUTO ADJUST button on  
the cabinet or the remote control.  
To USB port of  
PC or Macintosh  
R
GB  
I
NPUT  
AU  
IN  
D
To Mouse(PS/2)  
port of PC  
O
UT  
PU  
14 Picture Button  
T
PC  
-C  
O
UT  
O
NT  
RO  
L
S-V  
Press this button to display the Picture adjustment window.  
Each time this button is pressed, the current picture adjustment  
item will change as follows:  
ID  
EO  
V
ID  
Attach the supplied  
PS/2 Adapter  
R
G
B
T
IN  
PU  
RGB INPUT  
I
1
2
3
4
Infrared T ransmitter  
Direct the remote control toward the remote sensor on the projector cabinet.  
O
U
TP  
UT  
R
GB OUTPUT  
Zoom lever  
Brightness  
Contrast  
Color  
Hue  
Sharpness  
PC  
O
-C
U
T
NT  
IN  
R
O
Focus ring  
You can use the supplied wireless remote  
control and remote mouse receiver  
to operate your PC mouse wirelessly from  
across the room. See page E-14.  
L
S-VID  
EO  
V
ID  
LED  
EO  
Unavailable items will be skipped.  
Flashes when any button is pressed.  
15 Aspect Button  
Adjusting the T ilt Foot  
Power ON Button  
If the main power is applied, you can use this button to turn your projector on.  
Press this button to display the Aspect Ratio select window.  
Each time this button is pressed, the current aspect ratio will  
change as follows:  
P O W E R  
S T A T U S  
1
Press and hold the T  
projector .  
ilt button on the front of the  
O N  
O F F  
E T N E  
R
/
C
A
Power down all equipment  
before making connections.  
N
S E L E C T  
C
E
L
S O U R C E  
M
E
N
U
A U T O  
A D J U S T  
Power OFF Button  
If the main power is applied, you can use this button to turn your projector off.  
2
Lift the front edge of the projector to the desired  
height, and release the button to lock the  
able T ilt Foot.  
Normal  
Zoom  
Wide Zoom  
Cinema  
7m  
Adjust-  
NOTE: To turn off the projector, press and hold the POWER OFF  
button for a minimum of two seconds.  
You can also select the aspect ratio by using the Select or  
button. If no adustments are performed within 3 seconds, the As-  
pect Ratio select window will disappear. (See also page E-32.)  
A
U
D
IN  
30˚  
30˚  
2
T
I
1
5
VIDEO Button  
Press this button to select a video source from a VCR, DVD player,  
L
16 Help Button  
S O U R C E  
M
E
N
U
• To fine-tune the image’s position vertically on the screen,  
rotate the foot. Each of the rear feet height can be changed  
up to 0.6” (4mm).  
A U T O  
A D J U S T  
laser disc player or document camera.  
Provides information about the current signai and the status of  
the projector.  
Remote sensor on the  
remote mouse  
receiver  
6
7
S-VIDEO Button  
Press this button to select an S-Video source from a VCR.  
17 Freeze Button  
R
G
U
B
T
INP  
A
U
D
Monitor  
O
U
T
P
UT  
IN  
This button will freeze a picture. Press again to resume motion.  
P
C
-C  
O
U
O
T
T
RO  
L
S-V  
RGB Button  
ID  
EO  
V
ID  
Press this button to select an RGB source from computer or com-  
18 Picture Mute Button  
ponent equipment connected to your RGB port.  
This button turns off the image and sound for a short period of  
time. Press again to restore the image and sound.  
Step 2  
Connect the supplied power cable.  
U
N
E
E
RC  
M
8
Auto Adjust  
Button  
OU  
S
T
L
E
LEC  
SE  
C
AN  
C
OFF  
/
R
E
N
T
E
N
O
Use this button to adjust Position-H/V and Pixel Clock/Phase for an  
optimal picture. Some signals may not be displayed correctly, or in some  
cases it may take some time for a source to switch between sources.  
19 Magnify Button  
TUS  
TA  
W
ER  
S
PO  
Use this button to adjust the image size up to 400%.  
P O W E R  
S T A T U S  
20 V olume Button  
O N  
S T A N D B Y  
E T N E  
R
/
C
A
N
S E L E C T  
C
E
L
S O U R C E  
M
E
N
9
Menu Button  
Displays the menu.  
U
Press (+) to increase the volume and (–) to decrease it.  
A U T O  
A D J U S T  
NOTE: The default is the Computer mode, which allows you to use  
the Select, Cancel, and Enter buttons as your computer mouse.  
When the POWER ON/OFF, MENU, HELP or MAGNIFY button is  
pressed, the PJ button lights red to indicate that you are in the Pro-  
jector mode. If no buttons are pressed within 10 seconds, the light  
goes out and the Projector mode is canceled.  
10 Select (  
) / (mouse) Buttons  
When you are in the Computer mode, these buttons work as a computer mouse.  
R
G
U
B
T
IN  
P
A
U
D
• If the projected image does not appear square to the screen then use keystone correction for proper adjustment.  
Printed in China  
O
U
O
T
N
S
-V  
ID  
E
O
When you are in the Projector mode, which is indicated by lighting the PJ button:  
V
ID  
:
:
Use these buttons to select the menu of the item you wish to adjust.  
Use these buttons to change the level of a selected menu item.  
7N8P1131  
 

Miele Dishwasher G 865 User Manual
Milan Technology Switch E FX HB 0800 User Manual
MSi Computer Accessories IM GME965 User Manual
Multiquip Projection Television GB114BW User Manual
Nikon GPS Receiver GP N100 User Manual
Nortel Networks Telephone Call Center Telephone User Manual
North Star GPS Receiver GM9571M User Manual
NuTone Door LA310CY User Manual
Omron Blood Pressure Monitor i Q132 User Manual
Oster Mixer 2382 User Manual